blob: 3bc760cc31cbbeee3487230db7a4cd40fe0ff12b [file] [log] [blame]
sii902x HDMI bridge bindings
Required properties:
- compatible: "sil,sii9022"
- reg: i2c address of the bridge
Optional properties:
- interrupts: describe the interrupt line used to inform the host
about hotplug events.
- reset-gpios: OF device-tree gpio specification for RST_N pin.
- iovcc-supply: I/O Supply Voltage (1.8V or 3.3V)
- cvcc12-supply: Digital Core Supply Voltage (1.2V)
HDMI audio properties:
- #sound-dai-cells: <0> or <1>. <0> if only i2s or spdif pin
is wired, <1> if the both are wired. HDMI audio is
configured only if this property is found.
- sil,i2s-data-lanes: Array of up to 4 integers with values of 0-3
Each integer indicates which i2s pin is connected to which
audio fifo. The first integer selects i2s audio pin for the
first audio fifo#0 (HDMI channels 1&2), second for fifo#1
(HDMI channels 3&4), and so on. There is 4 fifos and 4 i2s
pins (SD0 - SD3). Any i2s pin can be connected to any fifo,
but there can be no gaps. E.g. an i2s pin must be mapped to
fifo#0 and fifo#1 before mapping a channel to fifo#2. Default
value is <0>, describing SD0 pin beiging routed to hdmi audio
fifo #0.
- clocks: phandle and clock specifier for each clock listed in
the clock-names property
- clock-names: "mclk"
Describes SII902x MCLK input. MCLK can be used to produce
HDMI audio CTS values. This property follows
consumer binding.
If HDMI audio is configured the sii902x device becomes an I2S
and/or spdif audio codec component (e.g a digital audio sink),
that can be used in configuring a full audio devices with
simple-card or audio-graph-card binding. See their binding
documents on how to describe the way the sii902x device is
connected to the rest of the audio system:
Note: In case of the audio-graph-card binding the used port
index should be 3.
Optional subnodes:
- video input: this subnode can contain a video input port node
to connect the bridge to a display controller output (See this
documentation [1]).
[1]: Documentation/devicetree/bindings/media/video-interfaces.txt
hdmi-bridge@39 {
compatible = "sil,sii9022";
reg = <0x39>;
reset-gpios = <&pioA 1 0>;
iovcc-supply = <&v3v3_hdmi>;
cvcc12-supply = <&v1v2_hdmi>;
#sound-dai-cells = <0>;
sil,i2s-data-lanes = < 0 1 2 >;
clocks = <&mclk>;
clock-names = "mclk";
ports {
#address-cells = <1>;
#size-cells = <0>;
port@0 {
reg = <0>;
bridge_in: endpoint {
remote-endpoint = <&dc_out>;